For best tech support results. Make a video of your install and issues,
Email a full descriptions of the issues your are having, and email info@northwestoverland.org the description and video.
then after you have done that. Text 503-395-4848 and We will respond. To Start the support process a video, and email needs to be sent, so that we can help you with all our recourses, and FAST as possible.
Your time is money we understand, so we are here to help. Thankyou.
Downloadable update PDF installation instructions
at the end/ bottom of this page!
NOTE 1: The Speed Option wire is not used, if you did not purchase or upgrade to having door speed option.
NOTE 2: The Extra Red and Black Wire coming from harness, after the main motor is not used if you did not get the upgrade option for an upper motor.
Help Pages
Alex Original Electric Power Sliding Door : Half Open or Half Closed Programming Mode and Help
HOW TO RESET THE MODULE
TURN VAN OFF
UNPLUG BLACK PLUG THAT GOES INTO BOARD
PLUG BLACK PLUG BACK IN
TURN VEHICLE ON – YOU WILL SEE RED LIGHT ON THE PCB BOARD TURN ON
PRESS AND HOLD THE DOOR SWITCH 10 SECONDS.
THIS SHOULD RESET THE BOARD
Alex Original Electric Sliding Door Remote control Programming
Alex Original Electric Sliding Door
- WORK IN PROGRESS
- Alex Original Electric Sliding Door Main Drive assembly installation instructions and help (Click)
- Alex Original Electric Sliding Door Lock installation instructions and help
- Alex Original Electric Sliding Door Lock installation instructions and help
- Alex Original Electric Sliding Door Lock installation instructions and help
- Alex Original Electric Sliding Door Locking latch installation instructions and help
- Alex Original Electric Sliding Door Contact holder installation instructions and help
- Alex Original Electric Sliding Door Contact panel installation instructions and help
- Alex Original Electric Sliding Door Lower Arm installation instructions and help
- Alex Original Electric Sliding Door Door Handle and Upper Actuator Assembly panel installation instructions and help
- Alex Original Electric Sliding Door Door Conveyor installation instructions and help
- Alex Original Electric Sliding Door Belt Clamp Pin and Ring installation instructions and help
- Alex Original Electric Sliding Door Rear Wheel installation instructions and help P.N. 2032-324
- Alex Original Electric Sliding Door Rear Wheel Cover installation instructions and help P.N. 3801-855
- Alex Original Electric Sliding Door Door Switch installation instructions and help P.N. 1050-8261
Q&A FAQ Alex Original Electric Sliding door technical support
Do you know if it is passable to set the door so that it only opens 1/2 way and close again?
Yes this is a option on the PCB Board
Do you have a separate electric sliding door remote to open the door and close?
Yes this is an option.
- This option is as following or the original key or separate remote controls
- The additional remote controls has to be purchased separately
on page 23 it says “optional! For high roof only upper lock assy” Do I need to do this install work? Was it part of the kit? And should I install it?
The upper locker are mostly used when the vehicle is a H3, this locker prevent that the sliding door can start vibrating in wind when driving.
It is according the customer if he find it needed to install the upper locker, some do and some don’t
If you refer back to image 29 and 30 in the install manual there seems to be some connector not installed on this van, or is there a workaround to this discrepancy?
In case there are no original contacts on the sliding door please contact the to as shown of the front door.
So seems the issue is the push pull actuator doesn’t seem to be in sink with the closing sequence….the door doesn’t lock properly an takes 3 times to lock.
a—————————————-
December 2023 Updated
2007-2018 NCV3 Mercedes Sprinter 906 RH USA Installation Instructions
December 2023 Updated