Connect the wires from the Remote to the micro switch (DO NOT PRESS REMOTE BUTTON WHILE THE HANDLE IS NOT BEING PULLED -EVER)

    Pull the jumper J2, Wait 3 seconds. Put the J2 jumper back on.

    Do this while the Ignition is on, and the Red light is on and the PCB Board is in full on operation.

      Pull the handle of the door to engage the micro switch, this only should engage at the end of the pull.

      Adjust the microswitch with the bolts so when you pull the handle the cable tension cause the microswitch to press and activate the remote. (Blue Light will turn on while engaged)

      Push button on remote at same time, Release.