Installation Help and Information for Black Horse Off Road Transporter Running Boards for the Ram Promaster Van TR-D13596
Installation Instructions: Black Horse Off Road Transporter Running Board TR-D13596
Fits:
- 2014-2025 Ram ProMaster 1500, 2500, and 3500 (136″ & 159″ Wheelbase, High Roof Cargo Van)
Tools Needed:
- Socket set
- Ratchet wrench
- Drill with 5/16″ drill bit (for support bracket attachment)
- Tape measure
- Marker or center punch
- Safety glasses
Installation Steps:
- Preparation:
- Remove all contents from the box and verify all parts and hardware are included.
- Park the van on a flat surface and ensure the vehicle is secure.
- Driver Side Installation:
- Locate factory holes in the inner body panel along the driver side. If covered with rubber plugs or sealant, remove them.
- Insert the 8mm bolt plate with a plastic retainer into the factory hole to secure it in place.
- Attach the driver side front mounting bracket to the bolt plate using 8mm hardware (flat washer, lock washer, hex nut). Keep hardware loose.
- Support Bracket Installation:
- Install the unique driver side front support bracket to the front mounting bracket using the included hardware (8mm x 25mm bolt, washers, nylon lock nut).
- Align the top of the support bracket with the vehicle’s pinch weld, but do not tighten completely.
- Rear Mounting Bracket:
- Locate the factory hole in the floor panel for the rear bracket.
- Insert the bolt plate and attach the rear mounting bracket using 8mm hardware.
- Secure the rear support bracket to the rear mounting bracket using the provided bolts, washers, and nuts.
- Running Board Installation:
- Insert the 6mm T-bolt plates into the tracks on the bottom of the running board.
- Place the running board onto the brackets, guiding the studs through the bracket slots.
- Use 6mm flat washers, lock washers, and hex nuts to loosely secure the running board.
- Adjust and Drill Support Brackets:
- Level and adjust the running board position.
- Mark the pinch weld locations for the support bracket slots using a marker.
- Remove the running board and brackets temporarily.
- Drill two 5/16” holes at the marked locations (avoid drilling through the welds).
- Secure Support Brackets:
- Reattach the support brackets to the pinch weld using 8mm x 25mm bolts, washers, and nylon lock nuts.
- Reinstall the running board and ensure it is level.
- Final Tightening:
- Tighten all hardware securely, including bracket bolts and running board mounting hardware.
- Passenger Side Installation:
- Repeat steps 2 through 8 for the passenger side using the same process.
Tips & Recommendations:
- Professional installation recommended for first-time installers.
- Periodically inspect all hardware to ensure it remains tight.
- Wax the running board after installation to protect the finish.
Estimated Installation Time:
- Professional: 1+ hours
- First-time installer: 2+ hours
For questions or additional support, contact Northwest-Overland.com tech support. Enjoy your new Black Horse Off Road Transporter Running Board upgrade!