Alex Original ESD Electric Sliding Door 7486-1393 ⚙️ How to Correctly Program the Remote on Alex ESD:

⚙️ How to Correctly Program the Remote on Alex ESD:

Step-by-step:

1. Ignition Key OFF
   (System must not be active — key off.)
2. Locate the ESD Electronic Control Box
   (It’s the black box with jumper pins labeled J1 and J2.)
3. Remove the programming jumper from its normal storage location.
4. Insert the jumper into J1 (Door Handle Programming Mode).
5. Hold the sliding door handle in the open position for ~3 seconds.
   • You should see LED 1 flash once to confirm.
6. Remove the jumper after LED flashes.
   • Important: Remove it within 15 seconds to avoid timeout.
7. Now reinsert the jumper to its “OPEN/FULL” storage socket (typically near the side of the control box).

🚪 Door Handle Test:

• Pull inside or outside handle gently — door should now command open/close.
• (If it still doesn’t, microswitch wiring or adjustment might need to be checked.)

📋 Common Mistakes That Cause Programming to Fail:

⚡ Summary for You:

🚨 If you need to program the actual Remote Fob (Key Fob):

Use J2 programming mode:

Steps:

1. Remove jumper.
2. Insert jumper into J2 (Remote Control Programming Mode).
3. Press the remote button for 3 seconds.
4. LED 13 will blink to confirm.
5. Remove jumper within 15 seconds.
6. Repeat for second remote if needed.